How to distinguish the merits and demerits of FRP lighting tile

When it comes to FRP lighting tile (glass steel tile), it has been popularized to the necessary building materials for roof building lighting. We may not be strange at all. After all, the lighting tile of energy-saving and environmental protection new building materials facilitates our life, and also changes the new situation of traditional roof lighting.

But with the more widely used daylighting tile industry, some small workshop manufacturers also began to study FRP daylighting tile, and they use backward equipment, and inferior raw materials, to study how to save costs, and obtain high profits.

The light plate on the market now, it is recommended that customers buy the light plate with the naked eye to identify the thickness of the first, if the light plate stacked up is flat, there is no stealing thickness if both sides or four sides are up, is poor lighting tile, there is a way to identify the thickness of lighting tile, is to weigh or shear mining light plate thickness comparison.

If the selection of "unscrupulous" manufacturers of the poor quality light plates, will bring what kind of harm to our production and life?

1, poor lighting tile surface uneven

Poor FRP lighting tile due to jerry-building, the thickness of the product produced is not uniform, and there are obvious bubbles and pine egg-shaped snowflake cracks, which will seriously affect the lighting effect.

2, poor lighting tile section thickness is different

Inferior FRP lighting tile section four sides thick middle thin, the overall stack can be seen like a ship, feel very poor, easy to step on the accident when installing the light plate, bring great harm to our body and mind.

3, poor lighting tile transparency

Now there are yellow lighting tiles on the market, and green lighting tiles, which should be caused by the use of inferior raw materials so that the production of FRP lighting tile life is short, the use effect will decline.

4, poor lighting tile toughness

Poor toughness of the light mining plate softness is not enough, too tough, and no adsorption force, in the nail installation will break a large piece of the phenomenon. The reason is that there are problems in the proportion of raw materials in the production of light mining plates. In the industry, that is to say, the resin is less than the glass fiber. After all, the resin is more expensive, and the toughness of the FRP light mining plate is poor and easy to break.